
A.2 Technical Specifications
1. Tuner & Demodulator
Parameter Specifications
Input Frequency
Range
950 MHz to 2150 MHz
RF Input Signal Level -25 to –65 dBm
RF Impedance 75œ
IF Bandwidth 55 MHz/8 MHz (under 5 Msps)
LNB Power 13/18 VDC, 14/19 VDC +/- 5%, 0.5A max, 0.8A peak
overload protected
No front panel display The power cord is not
plugged in.
Check power switch on back
panel is turned on.
Wrong connection of the
Audio/Video outputs of the
receiver to TV.
Ensure TV is tuned or
switched to correct input.
Wrong connection of the
antenna.
Check LNB connections are
not shorting.
No or Bad signal message
appears.
Check other device
connected between Antenna
and the receiver, or adjust
the antenna position.
No picture or sound
Audio muting Press the MUTE button
No or poor signal. Check antenna cable or
connect it to the receiver
securely.
No picture
Incorrect settings of some
tuner parameters.
Set the values of tuner
parameters correctly. Refer to
the Installation menu.
The UHF Antenna is not
optimized.
Adjust the antenna.
Signal too strong. Connect a signal attenuator
to the input.
No or bad UHF signal
UHF Antenna is too small. Change to a larger antenna.
Remote control does not
operate
Remote control batteries
are exhausted or not
inserted.
Check batteries are inserted
correctly. Replace leaky or
used batteries.
Poor picture quality
Less channels in scan
Cable has signal or power
loss.
Change the LNB power in
Dish menu. Check cable.
Kommentare zu diesen Handbüchern