Manhattan 176767 Bedienungsanleitung PDF herunterladen (Seite 5)

instantaneous protection from a single disk failure. If a read failure occurs

on one drive, the system reads the data from the other drive.

BIOS INSTALLATION (RAID SETTING)

Creating and deleting RAID sets is a function found in the BIOS (basic

integrated operating system). During boot up, the RAID setting message

will appear and pause for a few moments to allow you to choose what

to do. This board will act as a normal non-RAID card when BIOS is not

congured for RAID. Just proceed to Driver Installation. N OTE: If using

a traditional parallel ATA hard drive, make sure it’s set up in master mode

rst.

Creating Striped Sets (RAID 0)

1. As the BIOS boots, press CTRL+S or F4 to enter the raid bios utility.

2. Select "Create RAID set." Press Enter.

3. Select "Stripe," then press Enter.

4. Select "Auto conguration." Press Enter.

5. Press Y to save your settings.

6. Press CTRL+E and then press Y to exit the setup.

7. Continue with conventional Fdisk and Format steps as if installing a

conventional hard drive.

8. Your RAID conguration is complete. Proceed to Driver Installation.

Creating Mirrored Sets (RAID 1)

1. As the BIOS boots, press CTRL+S or F4 to enter the Raid bios utility.

2. Select "Create RAID set." Press Enter.

3. Select "Mirrored," then press Enter.

4. Select "Auto conguration." Press Enter.

5. Press Y to save your settings.

6. Press CTRL+E and then press Y to exit the setup.

7. Continue with conventional Fdisk and Format steps as if installing a

conventional hard drive.

8. Your RAID conguration is complete. Proceed to Driver Installation.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Manhattan 176767 Bedienungsanleitung Seite 5